DHCP Log - Click this button to see the IP addresses which have been allocated by the DHCP Server to PCs and other DHCP clients.If another device on your network will be the DHCP server, or if you will manually configure all devices, clear the Use router as DHCP server check box. Use router as DHCP serverīy default, the router will function as a DHCP (Dynamic Host Configuration Protocol) server, providing TCP/IP configuration for all computers connected to the router's LAN. However, if one router uses multicasting, then all routers on your network must use multicasting. Note: Multicasting can reduce the load on non-router machines because they do not listen to the RIP multicast address and will not receive the RIP packets. Both RIP-2B and RIP-2M send the routing data in RIP-2 format. RIP-1 is probably adequate for most networks, unless you have an unusual network setup. Disabled will disable the RIP feature completely.(It recognizes both formats when receiving.) By default, this is set for RIP-1. RIP Version: This controls the format and the broadcasting method of the RIP packets that the router sends.
![what is the default ip address for netgear router what is the default ip address for netgear router](https://routhelogn.com/wp-content/uploads/2018/07/default-ip.jpg)
When set to None, it will not send any RIP packets and will ignore any RIP packets received.When set to Both or In Only, it will incorporate the RIP information that it receives.When set to Both or Out Only, the router will broadcast its routing table periodically.The RIP Direction selection controls how the router sends and receives RIP packets. RIP Direction: RIP (Routing Information Protocol, RFC1058 and RFC1389) allows a router to exchange routing information with other routers.Unless you are implementing subnetting, use 255.255.255.0 as the subnet mask (computed by the router). Your router will automatically calculate the subnet mask based on the IP address that you assign.
![what is the default ip address for netgear router what is the default ip address for netgear router](https://www.downloads.netgear.com/files/answer_media/daryn_images/R7000_label%402x.png)
IP Subnet Mask: The subnet mask specifies the network number portion of an IP address.IP Address: Type the IP address of your router (factory default: 192.168.0.1).
![what is the default ip address for netgear router what is the default ip address for netgear router](https://www.informatiweb.net/images/tutoriels/reseau/netgear-wndr4300/ip-wan-routeur/1.jpg)
RIP is applicable if your network contains multiple routers. These are advanced settings that you may configure if you are a network administrator. The default values are suitable for most users and situations.